About a year ago I started to use the FRDM-KL25Z board (RevD). Finally, I had it in my hands: the RevE board from Mouser 🙂 Using the RevD board, I faced several problems:
The good news: all of them have been improved 🙂 in the FRDM-KL25Z RevE Schematics:
FRDM-KL25Z RevE Board
You have decided: More than 52% voted in Part 1 that the next topic should be Timed Servo Moves. So here we go :-).
This is about how to move the servos over time, instead of moving it to the given position as fast as possible. I’m using a linear approach here: moving the servos linearly over time.
Moving Servo Motors
Yesterday the local television station Tele 1 collected film material for a report about the “Julier” Formula Student team. The team did run more tests on the Alpnach air field, and this time the weather was much better compared to the last weekend. With the risk to get sun burned 😉
Until Tele 1 publishes the material, I have here pictures from the scene, the team and the car.
Camera, and Action
While weather is bad and Switzerland suffers from record high rain water levels, the Formula Student “julier” team was testing their race car this week-end after the rollout. This time to test the 4WD with more torque. Plus water-resistance ;-). So here are impressions, pictures and a video from this week-end:
Julier Formula Student Race Car
This post starts a small (or larger?) series of tutorials using the Arduino Motor/Stepper/Servo Shield with the FRDM-KL25Z board. That motor shield is probably one of the most versatile on the market, and features 2 servo and 4 motor connectors for DC or stepper motors. That makes it a great shield for any robotic project :-).
Arduino Motor Stepper Servo Shield with FRDM-KL25Z
Character LCD’s (like 2 lines with 16 characters each) as in this post are easy to use. Much easier to use compared to full graphical LCDs.
The ones I’m using have either 1 or 2 lines, but I saw that there are 4 line displays too. So far my LCD component only supports one or two lines.
4 Line LCD (Source: Ezequiel Bazotti)
The FRDM-KL25Z tracked robot from my earlier post has gone trough several upgrades:
Tracked Robot with Ultrasonic Sensor
Not everyone is familiar with Git, and not everyone wants to use it. Although I think using Git or SVN is something every software engineer today needs to master 😉 To make it easier for the ‘non-Gitter’ to use the Processor Expert components, they are available now as *.PEupd files as described here. However, the *.PEupd files are just a snapshot, and not the latest and greatest. So how to use the latest component sources and example projects without Git?
gits in a box
Last Thursday the new Formula Student race car named ‘julier’ had its rollout to the public at Sauber Motorsports in Hinwil, Switzerland. Again a fully electrical racing car, but this time with 4-wheel drive, improved aero-pack and electronics, and able to get from 0 to 100 km/h in 2.6 seconds!
Julier racing (Source Benjamin Hildebrandt)
Beside of USBDM, there is another Open Source implementation of a debug interface for the Freedom Board OpenSDA: CMSIS-DAP.
CMSIS-DAP (Source: http://nimblemachines.com/cmsis-dap/)
CMSIS-DAP stands for ‘Cortex Microcontroller Software Interface Standard – Debug Access Port’) has been published by ARM Inc. With this, there is an open source alternative to proprietary implementation (e.g. P&E OpenSDA or Segger OpenSDA).
Beside of the ARM MDK IDE, CMSIS-DAP is supported by Coocox and IAR. And IAR is what I’m using in this post.
MCU on Eclipse 